Krell Industries MASTER REFERENCE SUBWOOFER User Manual download pdf (Page 40)

(SECTION FOUR: Connections and Configurations continued)

(Step II. Connecting the Master Reference Subwoofer to Your System continued)

7. Plug the AC power cord into the IEC connector on the subwoofer back panel.

Plug the other end into the AC outlet.

IMPORTANT

The CAST and LFE inputs must be enabled through the menu to be operational. To

activate the low frequency effect (LFE), see Choosing Stereo, LFE, or Stereo/LFE,

below.

B. To Activate CAST Inputs

Use the menu to select which CAST inputs to enable.

1. Press the menu key (37).

2. Use the adjust keys (43) to select the CAST menu. The front panel display (4)

shows

CAST.

3. Press the enter key (38). The front panel display shows CAST MAIN.

4. Use the adjust keys to select the preferred setting. Options are:

CAST MAIN Enables CAST for the main input.

CAST LFE Enables CAST for the LFE input.

CASTNONE No CAST inputs are enabled.

CASTALL Enables all CAST inputs.

5. Press the enter key to set the selection and return to the main menu.

6. Press the menu key to exit the menu mode.

Note

All CAST inputs specified in the selected menu must be present before the Master Reference

Subwoofer will switch to CAST. For example, if the system is set for

CASTALL but there are

no connections to the LFE input, no CAST switching will occur.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 57 58

No comments

Krell Industries MASTER REFERENCE SUBWOOFER User Manual Page 40