Krell Industries KRC 2 User Manual download pdf (Page 6)

E. INPUT AND OUTPUT

CONNECTIONS

CAUTION: When making connections to this component

or any other, make sure tlie power amplifier is OFF.

CAUTION: Make sure all cable terminations are of the

highest quality, free from frayed ends, shorts or cold

solder joints.

1. Connect t.he left and right outputs of your source com-

ponents t.o the inputs on the KRC-2. The KRC-2 is

equipped with 4 single-ended inputs., 2 balanced capable

inputs, a single ended tape input and tape output.

The single-ended and balanced inputs are labeled S-1

througti S-4, B-1 a.nd B-2 respectively, to allow

customization in the set-up otyour system. There is. no

difference between the four single-ended inputs, or ~e-

tween the two balanced inputs.

2. Connect the output of the KRC-2 to the input of your

power amplifier. The KRC-2 has both Balanced outputs

via standard XLR type connectors and single-ended

outputs via standard-RCA type connectors.

Thepin assignment for the XLR connectors is:

pin _1-= shield (ground)

p!n 2 = non-inverting input (hot)

pin 3 - inverting input

NOTE: The RCA center conductor for each channel is

wired in para!lel with pin 2, the non-inverted output.

Only one of these outputs should be connected to a single

stereo amplifier.

NOTE: When connecting inputs or outputs to the KRC,

remember the balanced connections will have 6dB of

gain .m.ore than the single-ended connections. When level

matching is critical in your install, keep this specification

in mind.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

No comments

Krell Industries KRC 2 User Manual Page 6